Traxxas TMAXX t-maxx electric motor mount 540 550 brushed brushless conversion

Description

Traxxas Tmaxx 2.5 electric motor mount.
Fits 540 and 550 size brushed or brushless motors.
Mounts to existing chassis screw holes, you will need to remove the fuel tank and battery/switch box.
Motor screw holes are
25mm
apart.
3D printed with black Premium PLA+ thermoplastic
.
Motor not included, you will receive the mount and the mounting screws.
Your item will be shipped via USPS First Class Package with tracking included.
See our other listings for the battery and ESC mount.
Recommended setup:
2.5 TMAXX with a two speed transmission and reverse
540 – 550 sized motor, brushed or brushless.
ESC capable of forward only.
3s 5000mah or similar battery pack.
A channel splitter (servo Y harness) to run the brake servo and ESC together on
the receivers throttle channel.
If the brake engages while going forward you will need to reverse the
motors polarity and reverse the throttle channel on your transmitter.
Transmission adjustments, adjust gear settings so that the forward and
reverse gears engage at low RPMs.
Tune the shift point of the second speed to happen sooner.
– Turn
the adjustment screw 1/8 turn counterclockwise to lower the shift point (earlier
shifts)
– Use
1/8 turn increments to find the approximate, desired shift
point.
For a TMAXX with a forward only transmission
You will
need to use a ESC with reverse function if you want to have reverse.
Note: Some Basic Motor Tips
When
you attach the mount to the chassis use the included screws they should go upwards through the chassis screw
holes then thread up into the mount from underneath the chassis.
See the mounting screw location photo
for reference. Please be aware that some aftermarket chassis are
different than the original Traxxas chassis and might be missing some of
the screw holes needed.
Avoid
using any type of countersunk or small head motor screws to attach your motor to the mount.
Add flat washers to your motor screws or use the included large head motor screws, it will clamp more of the
mount surface preventing the motor from moving around and possibly damaging the mount or stripping your gears.
Motors with higher RPMs are better at reaching second
speed sooner.
Your motor
operating temperature range should be around 120°F to 150°F max. If you
start to see 150°F or more, it’s time to change your pinion/spur gear
ratio or check your drive train for binding. It is also a good idea to
add a motor heat-sink or cooling fan to your motor.